Installation of Roller Blinds

You will need

  • A pencil
  • Screwdriver (No.2 square-head)
  • Drill with 2mm drill bit

Inside Mount Installation

1. Mount brackets

Male bracket is for the chain control side of the blind, and female is for the pin (non-control) side.

Hold brackets onto window frame where they are to be fixed. Mark two screw hole positions and drill a pilot hole with 2mm drill bit.

Then screw-in brackets to window frame.

See male (left) and female (right) mounted below:

 Female bracket

2. Install blind

Remove blind from tube but leave securing tape in place at this stage.

Install blind into the male bracket first. (Note: before installing the blind into the bracket, make sure the top of the chain drive are facing upward (so opening for the chain is facing downwards):

 

Now remove securing tape from blind. Hold chain-side in position and move to the other side of the blind. Guide the metal spring loaded pin into female bracket track until it clicks into position:

Blind can be lowered using chain control. Once lowered, place the plastic chain stop on the chain where it enters the chain drive (prevents blind from being rolled down too far).

Outside mount installation

1. Mount brackets

Male bracket is for the chain control side of the blind, and female is for the pin (non-control) side.

Hold brackets onto window frame where they are to be fixed. Mark two screw hole positions and drill a pilot hole with 2mm drill bit:

Then screw-in brackets to window frame. See male (left) and female (right) mounted below:

2. Install blind

First remove the blind from tube. Do not remove securing tape from assembly at this stage.

Install blind into the male bracket first. (Note: before installing the blind into the bracket, make sure the top of the chain drive are facing upward (so opening for the chain is facing downwards):

 

Now remove securing tape from the blind.

Hold the chain-side in position and move to the other side of the blind. Guide the metal spring loaded pin into the track of the female bracket until it clicks into position:

Blind can be lowered using chain control. Once lowered, place the plastic chain stop on the chain where it enters the chain drive (prevents blind from being rolled down too far).

Removing the blind

To remove the blind, turn the large wheel at the pin end anti clockwise:

This action will slide the metal pin inward and the blind will slide out of the bracket.